Root element for the WildFly Command Line Interface configuration. The default protocol to use when controller addresses are supplied without one. The default protocol is used where a connection address is specified and no protocol is specified, in previous versions the port 9999 would have been used with the remoting protocol - this attribute set to true causes the protocol to default to remoting if the port number is 9999. If this attribute is set to false then the specified default is used regardless of the port number for addresses with no protocol. If no default controller is specifed then the default will be assumed to be using host 'localhost' along with the default-protocol (Which will be http-remoting if not defined) and the port will be whatever default corresponds to the selected protocol. The names controller alias mappings. Indicates whether the parameter list of the operation reuqests should be validated before the requests are sent to the controller for the execution. Whether to resolve system properties specified as command argument (or operation parameter) values before sending the operation request to the controller or let the resolution happen on the server side. The time allowed to establish a connection with the controller. Whether to write info and error messages to the terminal output. Even if the value is false, the messages will still be logged using the logger if its configuration allows and/or if the output target was specified as part of the command line using '>'. Whether the management-related commands and attributes should be filtered for the current user based on the permissions the user has been granted. In other words, if access-control is true, the tab-completion will hide commands and attributes the user is not allowed to access. In case the user attempts to execute a command or an operation without having sufficient permissions to do so, regardless of the value this element has, the attempt will fail with an access control error. The address of a controller. If no protocol is specified then the value for 'default-protocol' will be used. If a port is not specified then the default port will be identified based on the protocol selected. The name of this controller alias. This element contains the configuration for the commands and operations history log. This element contains the configuration for the Key and Trust stores used for SSL. Setting to true will cause the CLI to prompt when unrecognised certificates are received and allow them to be stored in the truststore. Element of this type points to a file with vault configuration. Absolute or relative file system path to the XML file containing the vault configuration. One of the system-provided named paths (such as jboss.home.dir, user.home, user.dir) relative to which the absolute path will be calculated for the path specified in the file attribute.